On 2/1/2018 at 4:41 PM, pastrygirl said:Sooo, I have to take back my mediocre review of the Grex 0.5 and Point Zero 1/5 hp compressor combo. The last few times I used them, getting color on the mold was super slow - I even filmed one to share with y'all but it took so long that I ran out of storage on my phone. I wasn't even sure i wanted to spend time fussing with it today, but I did a little maintenance - pulled out the needle and wiped some gunk off, then clipped the tip that was bent. And voila! Plenty of CB coverage in no time. Vastly faster. Clean tools - who knew?
(Usually I'm very clean in the kitchen, but i had not been taking the airbrush apart between uses, only rinsing with hot water.)
@pastrygirl did you have to make any modifications at all to the compressor, or is it pretty much plug and play?
Would you recommend the compressor if I needed to spray 8-12 molds at a time?
